18 November, 2021. Brake Setup and the Arduino.
The next step from the last post was re-bleeding the hydraulics, and then to see if the changes had worked.…
Author: Doug
7 November, 2021. Making random parts and the brakes better.
Leaks no more. Part of the previous exercises in messing with the engine was to stress test the cooling system…
26 October 2021. Getting the idle better.
Fuel Pressure – Fixing new parts 🙁 This is the new fuel pressure regulator installed. With the pressure sensor, later…
September 20, 2021. MPCNC Machining, 3D Printing and Wiring.
Again long time not update, the main focus I’ve had is to get the car ready to go to the…
April 24, 2021.
Its got to move. Looking back at my last post for the 21st of February, it seem such a long…
February 21, 2021. More fiberglass.
Firewall covers. After the excitement of getting the engine to run it was back to making fiberglass parts. One of…
January 18, 2021. Making it run.
With enough of the electrics done, I realized I was in a position to try and start the engine. That…
January 15, 2021. More electrics and some fiberglass.
Relays. With the mechanical’s of the drive train virtually complete the wiring had to be worked on next. The first…
December 26, 2020. Drive shafts.
In a change from working on electrics, the axles for the drive shafts arrived in the mail, so I decided…
December 15, 2020.
A job done some time ago but not shown, was to make bump stops for the suspension units. As supplied…