• Skip to main navigation
  • Skip to main content
  • Skip to footer

1TG – Design & Build of the One Tonne Guerilla

The Design & Build Diary of the One Tonne Guerilla.

Tag: 3D Printing (page 2)

June 21, 2020

June 21, 2020

Continuing with the 3D printing, this time in PLA I produced the prototype for the exit ducting for the radiators.…
Continue reading “June 21, 2020”…
Posted on: June 22, 2020 Last updated on: June 21, 2020 Written by: Doug
June 20, 2020

June 20, 2020

Carrying on from the last post, this is the radiator to floor brace welded up and bolted in place. And…
Continue reading “June 20, 2020”…
Posted on: June 21, 2020 Last updated on: June 21, 2020 Written by: Doug
April 17, 2020. Progress.

April 17, 2020. Progress.

Progress on the engine has stopped whilst I wait for parts to arrive. So the focus switched to other parts…
Continue reading “April 17, 2020. Progress.”…
Posted on: April 17, 2020 Last updated on: April 17, 2020 Written by: Doug

May 22, 2018. More rivets and glue.

Work has continued slowly gluing and rivet more panels to the frame. Wooden patterns were made to fit each section…
Continue reading “May 22, 2018. More rivets and glue.”…
Posted on: May 22, 2018 Last updated on: May 22, 2018 Written by: Doug

August 25, 2017. Yet More 3D Printing.

The pictures below show the overall plan for printing the front bodywork of the car.  The two grey flat areas…
Continue reading “August 25, 2017. Yet More 3D Printing.”…
Posted on: August 25, 2017 Last updated on: November 30, 2017 Written by: Doug
« Previous page 1 2
© 2023 1TG – Design & Build of the One Tonne Guerilla | Using Modern WordPress theme. | Back to top ↑