1TG - Design & Build of the One Tonne Guerilla site navigationSkip to content
  • About.
  • Books.
  • Links.
  • Toyota 1UZ-FE Engine to Audi 012 Transmission (Porsche G86) Adapter Drawings.
Search

1TG - Design & Build of the One Tonne Guerilla

The Design & Build Diary of the One Tonne Guerilla.

March 19, 2020.  Catch up Part 2

March 19, 2020. Catch up Part 2

Work was started on the fuel lines, the intention is to use hard line wherever possible and only use hose…

Continue reading "March 19, 2020. Catch up Part 2"…
19 Mar 2020 Comments: 0
March 03, 2020. Catch up Part 01

March 03, 2020. Catch up Part 01

Its been a long time since the last update, so here goes, this ma take more than one post. From…

Continue reading "March 03, 2020. Catch up Part 01"…
3 Mar 2020 Comments: 0
May 09, 2019.

May 09, 2019.

From the last post I’d folded the passenger side cover for the side box. however in the process of finishing…

Continue reading "May 09, 2019."…
10 May 2019 Comments: 0
February 13, 2019.

February 13, 2019.

Carrying on from the last post, after the foam was shaved down to size, I could then get on with…

Continue reading "February 13, 2019."…
13 Feb 2019 Comments: 0

December 28, 2018.

with the suspension back on I could determine where the front brake hoses would go through to the interior of…

Continue reading "December 28, 2018."…
28 Dec 2018 Comments: 0

December 1, 2018.

At the front of the car work has been been ongoing to seal the holes and gaps where the weather…

Continue reading "December 1, 2018."…
1 Dec 2018 Comments: 0

November 05, 2018. Catching up (Part 2).

So in the previous post I’d made a mess of the fuel tank cover, leaving that alone I went back…

Continue reading "November 05, 2018. Catching up (Part 2)."…
5 Nov 2018 Comments: 0

November 04, 2018. Catching up (Part 1).

I believed that’d I’d need to get the fuel tank enclosure finished before I could close in the side pods…

Continue reading "November 04, 2018. Catching up (Part 1)."…
4 Nov 2018 Comments: 0

August 14, 2018. Finishing the floor.

With all the pilot holes drilled the panel was then put back in place for final drilling… Then it was…

Continue reading "August 14, 2018. Finishing the floor."…
14 Aug 2018 Comments: 0

May 22, 2018. More rivets and glue.

Work has continued slowly gluing and rivet more panels to the frame. Wooden patterns were made to fit each section…

Continue reading "May 22, 2018. More rivets and glue."…
22 May 2018 Comments: 0
« 1 2 3 4 5 … 12 »
© 2021 1TG - Design & Build of the One Tonne Guerilla. Powered by WordPress. Theme by WebMan Design. Back to top ↑