After much stuffing about I’m getting somewhere with the CFD, some of the results of this are shown below: According…
Category: Project Status (page 3)
June 24, 2012. Mad Data.
I’m still struggling with openFOAM. The graph below shows what I’d expect to see on a typical run, notice the…
June 17, 2012. Body Design. OpenFOAM CFD.
I’ve started working on the design of the body more seriously than before. My previous attempts at using CFD software had…
December 17, 2011.
Below are some pictures of the car in the state it’ll go into storage, this is the most assembled in…
December 14, 2011.
Here is the chassis frame back from being sand blasted and primed. Since these were taken it’s had a coat…
November 2, 2011.
As usual its been too long since I updated the blog… The news is essentially the build of the car…
August 11, 2011.
I”ve not been home much for the last couple of months, hence not much has been done on the car.…
May 2, 2011
No progress to report as such, but used a Gigapan Epic 100 to take the image below. This is a…
April 23, 2011
Time for another monthly update. The tubes to which the side boxes on the car will be riveted – bolted…
February 25, 2011
A couple of other things I forgot to put in the previous post. There is a third baffle in the…