The pictures below show the overall plan for printing the front bodywork of the car. The two grey flat areas…
August 23, 2017, Fuel pump.
The fuel pump assembly is finally finished and bolted into the fuel tank. Which completes the fuel tank as well,…
July 23, 2017. Start of the sheet metal.
There is / was a design flaw in the car in that I didn’t pay too much attention to the…
July 22, 2017. The sheet metal bender.
Yet another big break between update, starting old and working to the new… Sheet metal bender I needed a sheet…
03 April 2017.
An update on the recent activity… I needed to get the car off of the ground to make it easier…
24-FEB-2017 More 3D Printing…
The 3D printing has continued to the point at which I had one whole side of the front bodywork, which…
24-Feb-2017 Project Update.
I have moved the radiator position to the rear of the car, this improves a few things. As I no…
25-Dec-2016, Windscreen and wiper workings.
Before the chassis frame is clad with aluminium sheet, there’s a few part that need to be sorted out as…
Dec 23, 2016. Out of hibernation.
After some 4 1/2 years away from the car, I was finally reunited with it in September. I’m hugely grateful…
June 05, 2016. Colour Scheme
This is a test post mainly but for a giggle… A couple of hours spent stuffing around with the rendering…