June 05, 2016. Colour Scheme
This is a test post mainly but for a giggle… A couple of hours spent stuffing around with the rendering…
Category: Project Status (page 6)
June 05, 2016. 3D Printing.
I’ve started to get on with my cunning plan for the use of the 3D printer… The intention is to…
January 31, 2016
Not much of an update, the virtual car next to the real one…
November 28, 2012.
After much stuffing about I’m getting somewhere with the CFD, some of the results of this are shown below: According…
June 24, 2012. Mad Data.
I’m still struggling with openFOAM. The graph below shows what I’d expect to see on a typical run, notice the…
June 17, 2012. Body Design. OpenFOAM CFD.
I’ve started working on the design of the body more seriously than before. My previous attempts at using CFD software had…
December 17, 2011.
Below are some pictures of the car in the state it’ll go into storage, this is the most assembled in…
December 14, 2011.
Here is the chassis frame back from being sand blasted and primed. Since these were taken it’s had a coat…
November 2, 2011.
As usual its been too long since I updated the blog… The news is essentially the build of the car…
August 11, 2011.
I”ve not been home much for the last couple of months, hence not much has been done on the car.…