The fuel pump assembly is finally finished and bolted into the fuel tank.  Which completes the fuel tank as well,…

There is / was a design flaw in the car in that I didn’t pay too much attention to the…

Yet another big break between update, starting old and working to the new… Sheet metal bender I needed a sheet…

An update on the recent activity… I needed to get the car off of the ground to make it easier…

The 3D printing has continued to the point at which I had one whole side of the front bodywork, which…

I have moved the radiator position to the rear of the car, this improves a few things.  As I no…

Before the chassis frame is clad with aluminium sheet, there’s a few part that need to be sorted out as…

After some 4 1/2 years away from the car, I was finally reunited with it in September. I’m hugely grateful…

This is a test post mainly but for a giggle… A couple of hours spent stuffing around with the rendering…