Category: Project Status (page 5)

The fuel filler hose passes through the cabin area of the car.  Therefore it needs to be enclosed to keep…

The fuel pump assembly is finally finished and bolted into the fuel tank.  Which completes the fuel tank as well,…

There is / was a design flaw in the car in that I didn’t pay too much attention to the…

Yet another big break between update, starting old and working to the new… Sheet metal bender I needed a sheet…

An update on the recent activity… I needed to get the car off of the ground to make it easier…

The 3D printing has continued to the point at which I had one whole side of the front bodywork, which…

I have moved the radiator position to the rear of the car, this improves a few things.  As I no…

Before the chassis frame is clad with aluminium sheet, there’s a few part that need to be sorted out as…

After some 4 1/2 years away from the car, I was finally reunited with it in September. I’m hugely grateful…