December 26, 2020. Drive shafts.
In a change from working on electrics, the axles for the drive shafts arrived in the mail, so I decided…
December 15, 2020.
A job done some time ago but not shown, was to make bump stops for the suspension units. As supplied…
November 21, 2020
Carrying on from the last post, to finish the fuel system there were some final parts to assemble and others…
November 7, 2020. Cooling system.
I’ve been taking a break from the wiring to focus on the cooling system of the engine. The original connections…
October 30, 2020.
Carrying on from the last post more wiring was needed for the engine, the wiring on the engine I’ve broken…
October 14, 2020
The 3D print of the air filter connection again failed, though it did look pretty. The part still split and…
October 9, 2020.
I’ve been told that the page with the transmission adapter drawings was not working correctly, so this has been fixed,…
September 10, 2020
A couple more bits completed by the welder. First the water pump inlet, prototype next to the finished thing… I’m…
August 30, 2020.
Carrying on from the previous post, to measure the movement needed to get the clutch to work, I sourced a…
August 3, 2020.
With the front suspension, steering completed for the minute, I returned to the MPCNC, It was clear that the issues…